Techmarkets Ltd design and manufacturing Company specialising in plastic products for the construction and furniture industries

Technical Data for EXFIX

Material Specification
Anchor Body:	Polypropylene Co Polymer
Expansion Pin:	Impact Modified, Glass Filled Polyamide 6
Application Temperature:	-30°C to +90°C
The anchor is not suitable for direct long term exposure to UV radiation.

Anchor Length mm	Head Diameter mm	Insulation Thickness mm	Minimum Embedment Depth mm	Drill Diameter mm	Drilling Depth into Base Material mm
60	50	0 to 30	30	10	50
90	50	30 to 60	30	10	50
110	50	60 to 80	30	10	50
130	50	80 to 100	30	10	50

Installation Procedure

Select the correct anchor length according to the guide to suit the thickness of insulation to be fixed.
Drill a 10mm diameter hole through the insulation into the base material. It is recommended that the hole is drilled at least 50mm in to the base material to allow for the expansion pin to clear the end of the fixing.
Insert the anchor body through the insulation and into the pre-drilled hole. Drive the anchor body in using a hammer until the head is level with the surface of the insulation.
Insert the expansion pin into the central hole in the anchor body and drive in with a hammer.
Drive the expansion pin until the head of the pin is level with the head of the anchor. Installation is completed.

Caution: The nail must be driven straight. Hammering at an angle may cause the nail to break.

Loading Performance
Base Material	Concrete (25)	Solid Brick	Concrete Block	Hollow Concrete Block
Pull out Load (Given in Kn)	0.80	0.75	0.70	0.45
These loads are ultimate loads. Appropriate safety factors must be applied for design purposes.