Techmarkets Ltd design and manufacturing Company specialising in plastic products for the construction and furniture industries

Technical Data for PANEL FIX

Material Specification Anchor body: Polymer Co Polypropylene.
Application Temperature Range:	-30°C to +90°C
The anchor is not suitable for direct, long term exposure to UV radiation.

Anchor Length mm	Head Diameter mm	Insulation Thickness mm	Minimum Embedment Depth mm	Drill Diameter mm	Drilling Depth into Base Material mm
50	35	0 to 20	30	8	50
70	35	20 to 40	30	8	50
90	35	50 to 60	30	8	50
110	35	70 to 80	30	8	50
130	35	90 to 100	30	8	50

Installation Procedure

Select the correct anchor length according to the guide to suit the thickness of insulation to be fixed.
Drill an 8mm-diameter hole through the insulation into the base material. It is recommended that the hole is drilled at least 50mm in to the base material.
Insert the PANEL FIX through the insulation in to the pre drilled hole. Drive the fixing in using a hammer.
Continue hammering until the head is level, or slightly recessed into the insulation to assist with any subsequent render finish. Installation of the fixing is completed.

Loading Performance
Base Material	Concrete (25)	Solid Brick	Concrete Block
Pull out Load (Given in Kn)	0.25	0.23	0.18
These loads are ultimate loads. Appropriate safety factors must be applied for design purposes.